Table of Contents
Advertisement
ASSEMBLY
10
Place the Top Shelf C upside-down on a soft
surface. Insert and tighten Cam Bolts 1 into
the 2 indicated holes near the center of the
Shelf.
Hardware Used:
11
Insert a total of 5 Dowels 3 into the indicated
holes in the top edge of the Left/Right Sides A/B
and the middle of the Upper Shelf Face H.
Slide the Upper Shelf Backer J into the grooves at
the rear of the Left/Right Sides.
Lower the Top Shelf onto the partially-assembled
unit by inserting the Cam Bolts into the Top
Divider F while sliding the Dowels into the
corresponding holes in the underside of the Top
Shelf.
Fasten the Cam Bolts by inserting a Cam Lock Nut
2 (with arrow pointed toward top edge) into the
holes in the side of the Top Divider adjoining each
Cam Bolt, then turning the Cam Lock Nuts
clockwise until secure.
Insert 6 Large Screws 5 through the Left/Right
Sides and Upper Shelf Face upwards into the
underside of the Top Shelf. Tighten securely using
a Phillips-head Screwdriver.
Hardware Used:
Check that all hardware is firmly tightened.
Your Greenwich Media Console is ready for use!
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
1
Cam Bolt x 2
2
Cam Lock Nut x 2
3
Dowel x 5
5
Large Screw x 6
C
C
3
5
3
5
5
1
1
J
2
5
5
B
5
Advertisement
Table of Contents
