Playing - Roland Kiwi Technics JX-3P Manual

B) Playing
www.kiwitechnics.com
Load Sequence
A Sequence can be loaded in two ways.
A Sequence is loaded manually by
pressing Seq Tie and then a Tone
button 1-16. The Sequence that is
stored under the Tone button selected
will be loaded to memory
.
A Sequence can be assigned to a
Tone and can load automatically
when the Tone is loaded. To do this
place the Sequence number 1-16 in
the Load Sequence Field (D-1) in the
Tone Parameter Editing. Place a zero
in this field (no editing lights on) if you
do not want a Sequence to load. The
last Sequence will stay in memory and
continue to play (if enabled) in this
case.
If you press the Start/Stop button the
indicator will light up and the data
written into the sequencer will be
played. If the seq clock is set to ext or
midi the first note of the sequence will
only sound once a clock has been
received. This allows a seq to be
queued to start. When all the notes are
played the data will return to the
beginning and be played again from
the start. Pressing the Start/Stop
button once more (it's indicator will go
out) will stop playing immediately. The
temp of the playing will be determined
by the clock source. If the clock
source is internal then the tempo will
be set by the Rate Knob. The Rate
Knob will have no effect if the clock
source is anything other than the
internal clock.
* If you stop the Sequence part
way through and then restart it
the data will start from the
beginning.
* If you wish to only play the data
once, put some rests are the end
so it is easier to stop the
sequence in the correct place.
It is possible to play along with the
sequencer. The 3P has 6 voices in total
and if not enough voices remain for all
the sequence note(s) then these will be
lost. i.e. if the sequence step has four
notes and three are being played then
one sequence note will not sound.
Note - If a new sequence or tone is
loaded while a sequence is playing
the load of the tone and Seq and
pattern will delay until the current
sequence reaches the end and is
about to loop back to the start. At
this point the Tone and Sequence (if
auto load enabled) and Pattern (if
auto load enabled) will then load and
the next note(s) to sound will be with
the new selection.
3P Upgrade User Manual v400
18