Global - Fine Tune; Global - Midi And General Settings - Roland Kiwi Technics JX-3P Manual

Internal Velocity

GLOBAL - Fine Tune

Fine Tune Offset

GLOBAL - Midi and General Settings

Midi In Channel
Midi Out Channel
Seq Midi Out Channel
Device ID
Local On/Off
Enable Midi CC Receive
Enable Midi Sysex Receive
Enable Midi Soft Through
note - real time midi commands will
always pass and B:8 will have no effect
Midi Soft Through Filter
note - if Midi In B:1 is set to omni all
midi will pass and B:9 will have no effect
note - SysEx intended for the 3P will not
be passed and B:9 will have no effect
Enable Midi Clock Generation
Enable Program Change Command
Enable Clock Display
Enable Voice Display
note - this setting is lost on power down
www.kiwitechnics.com
A-4 Range 0-127 - Sets Velocity Level for internal keys
A-16 Range ±63 (~±200 cents) - Note - this control is center
off
This will adjust the entire 3P and is independent of the
tune control on the rear of the 3P
B-1 Range 0-16 for Channels 1-16 & Omni (Default 0)
All Tone Lights will flash for OMNI
B-2 Range 0-15 for Channels 1-16
B-3 Range 0-15 for Channels 1-16
B-4 Range 0-16 for ID 1-16 & Omni
All Tone Lights will flash for OMNI
B-5 0 = Local Keyboard Off
1 = Local Keyboard On
B-6 0 = Midi CC Receive Disabled
1 = Midi CC Receive Enabled
B-7 0 = Midi Sysex Receive Disabled
1 = Midi Sysex Receive Enabled
B-8 0 = No Midi Passed
1 = Midi Passed depending on B-9 filter
B-9 0 = No Filter - all midi passed
1 = Filter all midi on 3P Input Channel
2 = Filter only midiCC on 3P Input
* = bank select, panic & MW CC will still be passed
B-10 0 = Midi Clock not generated
1 = Midi Clock Generated from Internal
B-11 0 = Program Change not sent
1 = Program Change sent
B-12 0 = Clock Display Disabled
1 = Clock Display Enabled
B-13 0 = Voice Display Disabled
1 = Voice Display Enabled
(Default 0)
(Default 0)
(Default 0)
(Default 1)
(Default 1)
(Default 1)
(Default 0)
(Default 0)
Channel*
(Default 0)
(Default 0)
(Default 1)
(Default 0)
3P Upgrade User Manual v400
30