KTM 125 XC-W 2018 Setup Instructions page 7

Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
E00483-01 or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
Info
The markings on the handlebar should be at the center
of the handlebar clamps.
Keep the gap widths equal when tightening.
(125 XC‑W EU)
–
Position the controls on the right half of the handlebar.
S01450-01
(150 XC‑W US)
–
Position the controls on the right half of the handlebar.
S01451-01
M8 20 Nm (14.8 lbf ft)
2 SETUP
5