Wheel Replacement - Grizzly G1095/G1096 Owner's Manual

Wheel Replacement

always disconnect power
to the machine before
performing installation
or maintenance. Failure
to do this may result in
serious personal injury.
to replace a worn out or damaged wheel:
1. disConneCt the poWer Feeder
FroM poWer!
2. using a 5mm hex wrench, remove the wheel
retaining cap screws (Figure 17).
-24-
Figure 17. Wheel cap screws.
3. swap the old wheel with the new one.
4. reinstall the four cap screws, and tighten in
an alternating pattern until the wheel is tight.
Model g1095/g1096 1-hp power Feeder
Cap
screw