Changing Speeds - Grizzly G1095/G1096 Owner's Manual

changing Speeds

always disconnect power
to the machine before
performing installation
or maintenance. Failure
to do this may result in
serious personal injury.
your power feeder has the option to feed a
workpiece at 13, 26, 33, and 66 feet per minute.
these rates are achieved by changing the combi-
nation of change gears, and by turning the motor
switch to high or low range operation.
to change the feed rate of your power
feeder:
1.
disConneCt the poWer Feeder
FroM poWer!
2.
Make sure the speed dial is pointing to "0"
(the OFF position, Figure 13).
Figure 13. Feed direction and speed dial.
Model g1095/g1096 1-hp power Feeder
3.
refer to the feed rate list below to find the
gear combination required for your chosen
feed rate.
13 Ft Per Min: a, 25 tooth + b,
40 tooth.
26 Ft Per Min: a, 40 tooth + b, 25
tooth.
33 Ft Per Min: a, 25 tooth + b, 40
tooth.
66 Ft Per Min: a, 40 tooth + b, 25
tooth.
Motor OFF.
4. remove the chain cover and the two hex
nuts securing the a & b change gears to the
shafts shown in Figure 14.
Change gear
position a
Change gear position b
Figure 14. Change gear locations.
5. swap the required change gears so the gear
hubs are facing in toward the power feeder
(shown in positions a & b in Figure 14).
6.
reinstall the hex nuts and chain cover.
7.
Connect the power feeder to power and
move the feed direction and speed dial to the
high or low range.
-21-