Table of Contents
Advertisement
Installing Internal Wheel
1.
diSConnECt lAthE And grindEr
FroM poWEr!
2.
if installed, remove the belt guard to access
the right-hand spindle.
3.
Examine the internal wheel. if there are
cracks, damage, or it is worn down to
its original diameter, replace it with a new
one (refer to accessories on Page 27 for a
replacement option).
4.
Use a wrench on the flats of the right-hand
spindle to keep it from turning, then fully
tighten the internal wheel onto the left-hand
spindle, as shown in figure 13.
internal Wheel
figure 13. internal grinding wheel installed.
changing Spindle Pulley & belt
1.
diSConnECt lAthE And grindEr
FroM poWEr!
2.
if installed, remove the belt guard to fully
expose the V-belt.
-18-
3.
loosen the two cap screws on the right
side of the grinder base so that the motor
mount can slide along the dovetail way (see
figure 14).
⁄
of
1
2
figure 14. Belt tensioning controls.
4.
turn the belt tensioning knob to move the
motor assembly forward toward the grinder
spindle, then roll the V-belt off the pulleys and
store it in a dry, protected area for later use.
5.
turn the spindle pulley screw shown in
figure 15 clockwise to remove it and the flat
washer from the spindle.
Note: The spindle pulley screw has left-hand
threads.
figure 15. removing the spindle pulley screw.
Cap Screws
External Spindle pulley
Model g0688 (Mfg. Since 9/08)
Belt
tensioning
Knob
Spindle
pulley
Screw
Advertisement
Table of Contents
