Beko Drypoint ACC 4 Instruction/Technical Manual page 27

Section 6: Maintenance
Resetting the Controller
• After following the start-up procedure it is necessary to
reset the controller. This is done by using the re-set disc
(supplied with cartridge service kit) then:
• Hold the disc against the blue pad on the front display of
the dryer panel for 5 seconds.
• During the five second period the power indicator will
flash green. When the reset has been successful indicator
X will flash green once to confirm that it has been
completed successfully.
Sweep the reset disc on the blue pad if the LEDs do not
flash as stated.
Please note: If Energy Management is activated,
their will be a 6 hour delay after reset before Energy
Management will be operational again.
Heatless Desiccant Dryers | Instruction Manual
Figure 6.9: Controller reset
Figure 6.10: Controller description
X
POWER
27