Beko Drypoint ACC 4 Instruction/Technical Manual page 11

Section 3: Mechanical Installation
Reconfiguration of the inlet / outlet ports
4 SCFM – 35 SCFM models
The dryer provides a choice of 3 inlet ports (A, B & C) and 3
outlet ports (D, E & F). Any inlet or outlet port may be used.
Make sure the remaining two inlet or outlet ports are blanked
off using provided pressure plugs. (Figure 3.5)
If desired, the port block may be removed and rotated 180° to
provide additional inlet & outlet port positions. (Figure 3.6)
Directional arrows are etched into the inlet manifold.
Any / all of the three outlet ports can be used on
occasion. Please ensure combined flow at outlet should
not exceed specification. Please adhere to regional
regulations.
It is strongly advised to connect a non-return valve to
each outlet used.
Only use one inlet port at any one time
Ensure original seals are in place.
Check dryer is leak-free prior to operation.
Tools required
• 4mm hex key
• 5mm hex key
Heatless Desiccant Dryers |
11
11
Instruction Manual
Figure 3.5: Inlet/outlet ports
F
A
B
Figure 3.6: Reconfiguration of inlet/outlet ports
C
D
F
E
E
3 3
7
7
C
B
A
E
F
D
E
D
C
B
C
B
A
A
F
D
6
6
11