Cabinet Door And Dead Front Removal For Ifp-300Ecs And Ifp-2100Ecs - Honeywell ECS Series Installation And Operation Manual

ECS Series Emergency Communication System Installation Manual 151455
Re-Attaching the Cabinet Door
To re-attach the cabinet door reverse the procedure in section 3.4.7.1.
3.4.7.2

Cabinet Door and Dead Front Removal for IFP-300ECS and IFP-2100ECS

While installing the cabinet it may be necessary to remove the cabinet door and the dead front panel.
This section provides instructions on how to remove the door and dead front panel for the IFP-300ECS
or the IFP-2100ECS.
1. Disconnect the connection between the ECS-NVCM and the ECS-EMG keypad.
2. Disconnect VBUS wiring from ECS-NVCM.
3. Slide the door or dead front over two pins in the hinge bracket of the base. The outer hinge pins
are for the door, the inner hinge pins are for the dead front. See Figure 3-12.
Hinge Pin
Dead
Front Panel
Cabinet Door
Figure 3-12 Cabinet Door and Dead Front Panel Removal
Re-Attaching the Cabinet Door
To re-attach the cabinet door, the top hinge should be aligned first, followed by the lower 3.4.7.2.
3-12