Water dispenser with mid-mount refrigerator (1 page)
Summary of Contents for Greenway Home Products GWD2630W-1
Page 1
MISE EN GARDE: Avant d'employer votre distributeur d'eau, lisez ce manuel et suivez toutes les règles de sécurité et les consignes d'utilisation. GWD2630W-1 PRECAUCIÓN: Antes de usar el dosificador de agua, lea este manual y siga todas las reglas de seguridad e instrucciones...
• Leave a minimum of 2” (5 cm) around the back and sides of the dispenser for proper ventilation. • Always install your water dispenser on a level counter. Wait 3 minutes before restarting machine after shutting down. • Always unplug the water dispenser before servicing or cleaning.
Page 3
YOUR GREENWAY WATER DISPENSER ® 1. Bottle support collar 2. Ready-To-Dispense indicator lights: Red: “flashing” Heater (hot tank) is in operation "on” The hot water has reached optimum temperature and is ready for dispensing "off" Heater (hot tank) is off, however remaining water within the tank still may be hot, always exercise caution when dispensing and/or draining water from the hot water tank.
3. Pour a water dispenser cleaner or a mixture of 4 cups / 1L of vinegar with 4 cups / 1L of hot water into the reservoir and wait 20 minutes.
Page 5
1-866-253-0447. If the water level remains constant it is the water bottle not the dispenser that is leaking. Please contact your water supplier for a replacement bottle. Please visit us at www.greenwayhp.com for water dispenser accessories and helpful use and care tips. Reservoir Lip...
Child Resistant Safety Switch To prevent hot water from accidentally harming a child, the hot water dispenser button has a safety switch on it. Slide the switch to the left and push the button down to dispense hot water. DANGER: The hot water is heated to approximately 201˚F / 91˚C.
Page 7
Cleaning the Outside of the Water Dispenser The outside of the dispenser can be wiped clean with a water dispenser cleaning solution or a mild soap and water mixture. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with clean water and then dry surfaces.
Page 8
2. Remove the water bottle and bottle support collar. 3. Drain the reservoirs (see Draining the Reservoirs, pg 6). 4. Pour a water dispenser cleaner or a mixture of 4 cups / 1L of vinegar with 4 cups / 1L of hot water into the reservoir and wait 20 minutes.
SPECIFICATIONS GWD2630W-1 Output per hr: Internal Tank Capacity: heating Temp (approx.): Cooling Temp (approx.): Power Consumption (Watts): Power Consumption (Amps): voltage TROUBlEShOOTING TIPS Problem Possible Cause Water dispenser Small pin hole or crack in the bottle, (common with is leaking recycled water bottles).
FREqUENTlY ASkED qUESTIONS q: Why is my water dispenser leaking? A: Many times a leak is caused by a defective water bottle with a small crack or pinhole (see Important Notice About leaking Bottles, pg 4). IMPORTANT: To avoid water overflow while cleaning the dispenser, always remove the bottle support collar before pouring water or cleaning solution into the reservoir (see Figure A, pg 3).
Need help?
Do you have a question about the GWD2630W-1 and is the answer not in the manual?
Questions and answers
Need a drain plug Cap