Rowenta AU56 F0 Series Instructions For Use Manual page 9

EN
INSTRUCTIONS D'INSTALLATION
1
2
3
4
5
7
6
8
9
10
11
12
1/ Control Panel
2/ Air Outlet
3/ Handle
4/ Caster
5/ Air Filter
6/ Air outlet (Heat exchange)
7/ Air intake (Evaporator)
8/ Air intake (Condenser)
9/ Water outlet drain
Note: please ensure if the water outlet drain is
well installed before use
10/ Power supply cord
11. Exhaust hose
12&13. Exhausted connectors
14. Exhaust nozzle
15. Wall flange accessory and cap
16. Window seal kit
14
13
15
16
Installation 1 - mobile installation
1/ Click the exhausted nozzle (#14) to the exhausted connector
2/ Slide the other exhausted connector (#12) to the air outlet (#6) on the rear of the unit (Fig 3)
Extend hose (#11) to desired length and position the exhausted nozzle (#14) through an open window
as shown on fig.4.
Fig. 3
INDOOR
Fig. 4
Semi-permanently installation
If required, your appliance can also be installed semi permanently (Fig. 5)
Proceed as follows:
• Drill a hole in an outside wall or through a window pane. Ensure the MIN / MAX dimensions for the
hole size and its position are adhered to (Fig.6 and 7).
• Fit the wall flange accessory (#15) provided in the hole.
• Insert another end of the hose assembly to the fixture previously fit on the wall a shown in (Fig. 6)
When the hose is not in use, place the cap (#15) on connector to cover the hole on the wall.
NOTE: When installing the air conditioner semi permanently, to maintain the balance of air pressure
between indoors and outdoors always leave an internal door slightly open.
16
MIN 30cm MIN 30cm
Fig. 5
17
EN