Advertisement
Device Installation/ 设备安装
B. Pole-Mount/ 立杆抱装
Install the camera:
4
1. Thread the network cable through the PG waterproof connector and tighten the PG waterproof connector.
2. Install the bullet camera on the universal joint, loosen the universal joint, adjust the shooting angle of the
bullet camera, and then tighten the screws on the universal joint.
安装摄像机：
1. 提前将防水部件穿过网线，拧紧 PG 防水接头。
2. 将筒机安装至万向节，拧松万向节，初步调整好筒机的角度后，再拧紧万向节上的螺钉。
Hex nut of the PG connector
PG 头螺母
Waterproof connector of the bullet camera/筒机防水接头
O-ring of the bullet camera/筒机防水圈
Waterproof cap of the bullet camera/筒机防水帽
PG connector screw cap/PG头螺帽
PG connector bushing isolator/PG头堵芯
PG waterproof connector/PG防水头
NOTE/ 说明
•There are three holes on the PG connector bushing isolator. The
smallest hole is used preferentially.
•Change the bullet camera IP address as planned before
installing the camera. Otherwise, you need to use the iClient SDC
tool to change the bullet camera IP address.
•The hex nut of the PG connector does not need to be installed
for this model.
•PG 防水堵芯有三个孔，网线优先使用其中最小的孔。
•
建议安装球机前先按照规划修改好筒机的 IP 地址，否则需要使用
iClient SDC 工具修改筒机 IP 地址。
•PG 头的六边形螺母在本款型中无需安装，可自行选择处理。
Install the top cover of the PTZ dome camera:
5
1. Align the top cover of the PTZ dome camera with the mount and screw it into the mount.
2. Lastly, use a Phillips screwdriver to tighten the set screws on the mount to secure the adapter ring to the
mount.
安装球机上盖：
1. 将球机上盖对准支架，然后旋转球机上盖，将上盖安装到支架上。
2. 最后用十字螺丝刀拧紧支架上的紧固螺钉，完成球机转接环的安装。
The PTZ dome camera is delivered with a handle attached, to make it easier to pick up and carry the camera. You
are advised to use the handle, not the pigtails, to carry the camera.
由于球机比较重，球机提手在出货的时候已经安装在球机上，便于施工时搬运球机；设备搬运的时候要求通过提手搬运，不
允许通过提尾线搬运设备。
Correct:
Carry the
camera
using the
handle
正确方式：
通过提手搬
运设备
4
4
Wrong:
Carry the
camera
using the
pigtails
错误方式：
通过尾线搬
运设备
Advertisement
