Advertisement
Device Installation/ 设备安装
A. SD Card Installation/ 安装 SD 卡
Use a 2# Phillips screwdriver to remove the bottom cover, insert the SD card.
使用 2# 十字螺丝刀将球机窗口盖卸下，插入 SD 卡。
CAUTION/ 注意
Do not disassemble the PTZ dome camera yourself or remove the lens protective film before the installation is
complete. Ensure that the weight bearing capacity of the pole, ceiling, wall and brackets exceeds 30 kg and the
installation environment is secure and reliable. Also, avoid magnetic interference nearby.
禁止私自拆解球机。安装完成前切勿撕下镜头保护膜。安装此设备的立杆、墙壁和支架，需确保在承重30Kg时稳定性较好，
并确保各安装环境的牢固、可靠。同时，应避免球机附近存在磁场干扰。
B. Pole-Mounted Installation/ 立杆抱装
Install the universal joint:
1
Use three M6 screws to secure the universal joint to the smart tracking mount, and then tighten the screws.
安装万向节：
使用三颗 M6 螺钉将万向节安装到支架上，然后拧紧螺钉。
B. Pole-Mounted Installation/ 立杆抱装
Secure the smart tracking mount to the pole mount:
2
Align the screw holes on the smart tracking mount with those on the pole mount, and tighten the M8 screws.
The tightening torque is 8 N.m.
将枪球联动支架安装至抱箍支架：
将枪球联动支架上的螺孔与抱箍支架上相应的螺孔对齐，拧紧 M8 螺钉。紧固力矩为 8N.m
3
Secure the mount to the pole:
1.Thread cables through the smart tracking mount
2.Loosen the three hose clamps and route them through the mounting holes on the pole mount. Then, route
the cables that need to be connected to the pigtails of the PTZ dome camera through the pole mount.
3.Place the hose clamps around the pole and fasten the hose clamps to fix the pole mount to the pole.
将摄像机支架安装至抱柱：
1. 提前将线缆穿过球机支架。
2. 将 3 个喉箍拧开，穿过抱装支架的安装孔，然后将需要与球机尾线对接的线缆穿过支架。
3. 将抱箍环绕在柱杆上，拧紧抱箍，将抱装支架固定在柱杆上。
3
The hose clamp latch is
tightly affixed to the pole
喉箍锁扣紧贴柱杆
Advertisement
