Timer Setting; Speed Button - Waykar PD160B User Manual

OPERATION INSTRUCTIONS
Power Button
Humidity Setting
-When it starts to work
（After you set the desired humidity, the readout will display the actual humidity.）
-If the room humidity level is higher than your setting value, the dehumidifier will automatically start working;
-When the humidity drops to what you desire, the dehumidifier will automatically stop and the "
the screen will flash, indicating the wet control status.
-When the humidity level is set at 30%RH, the dehumidifier will be at CONTINUOUS dehumidifying mode.

Timer Setting

When the unit is running, selecting TIMER will turn the unit off in the set hours
later (Delay Stop). When the unit is off, then the TIMER will turn the unit on in the hours you earlier
selected (Delay Start).
TIMER setting: Press or hold the Timer Button to change the delay timer at 1 hour increment, up
to 24 hours. After TIMER setting is finished, the control panel will display the remaining time (8, 7
or 6, etc.) until the unit starts or stops.
If then press TIMER button again, the control panel will display the room temperature and humidity
value as before. After that, adjust the TIMER setting to 00 will cancel the Auto Start/Stop function.
For the Delay Start, the fan speed and humidity maintained will be the same as previous setting.
NOTE
-Before entering TIMER setting, make sure power is being supplied to the unit.
-Before entering TIMER setting, make sure you press the Setting Button to set a desired
room humidity first.

Speed Button

Control the fan speed. Press to select either High or Normal fan speed. A higher fan speed will result
in quicker moisture removal.
P.05
" icon on