Forward-Facing Installation - Century 1000 STETM Instruction Manual

FORWARD-FACING INSTALLATION

1
Adjust car seat to upright position and place
forward-facing on vehicle seat.
2
Thread vehicle seat belt through openings and
behind harness straps (fig. a).
Buckle belt.
3
Press down firmly in center of car seat to compress
vehicle seat cushion while tightening vehicle seat
belt.
HINT: Use your knee to press down in center of
car seat (fig. b).
4
Pull front to back and left to right to check for
secure installation (fig. c). Vehicle lap belt
MUST stay tight.
If not secure, see "Vehicle Seat Belts" section.
5
Attach tether strap hook (A) to anchor hardware (B)
and tighten strap to remove any slack (fig. d).
If tether anchor hardware (B) is not available, see
"Installation of Anchor Hardware" section.
(fig. a) (fig. b)
Tether
Strap
Openings
(fig. c)
Stand
Pull to
tighten
(A)
(B)
(fig. d)
7