Century 1000 STETM Instruction Manual page 20

VEHICLE SEAT BELTS
Combination Lap/Shoulder Belt
with Sliding Latch Plate
Pull on latch plate (fig. a). If belt slides freely
through latch plate, a locking clip MUST
be used (see Locking Clip section).
Some combination lap/shoulder belts with
sliding latch plates may be converted into an
"automatic locking mode" that will allow use
without a locking clip. See vehicle owner's
manual and label on vehicle belts for
instructions.
Combination Lap/Shoulder Belt
with Locking Latch Plate
The locking latch plate on some seat belts may
slip and loosen after being buckled on car seat if
positioned at a certain angle. If this happens,
flip the latch plate over (fig. b) and re-buckle.
Test installation again to see if this works. If
not, move car seat to another seating position.
18
(continued)
Pull
(fig. a)
Flip
(fig. b)