Forward-Facing Installation With Vehicle Seat Belts - Century 44164 Instruction Manual

FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS

WARNING
LATCH belt MUST be stored when
using vehicle seat belt to install car
seat.
Store LATCH belt by attaching to openings in
1
top of car seat. (see page 24 fig. m).
• Hook connectors into storage openings
on each side of seat. (fig. a).
• Adjust LATCH
slack by adjustment belt.
Adjust car seat to upright position (see pages 18
2
and 19 Fig. c) and place forward-facing on vehicle
seat.
3
Thread vehicle seat belt through openings.
Buckle belt (fig. b).
Press down firmly in center of car seat to compress
4
vehicle seat cushion while tightening vehicle seat
belt.
Use your knee to press down in center of car seat
(fig. c).
10
belt to remove excess
5
Pull front to back and left to right to check for
secure installation (fig. d). Vehicle lap belt
MUST stay tight.
If not secure, see "Vehicle Seat Belts" page 25.
6
Attach tether strap hook (A) to anchor
hardware (B) and tighten strap to remove any
slack (fig. e) . If vehicle does not have anchor
points to attach tether hook, tether hook
should be stored, see "Tether Storage",
page 31.
Periodically check that car seat is securely
installed; adjust if necessary.