Table of Contents
Advertisement
Installation
• This appliance can be installed as a built under unit only. The clearances shown
in the below drawing must be followed.
• Avoid damaging the product during installation, positioning of the appliance
requires two people in order to avoid injuries or damage to the appliance.
• Your appliance should not be located in direct sunlight or exposed to
continuous heat or extremes of temperature (e.g. next to a radiator or boiler). If
this is not feasible, then you should install an insulation plate between the
appliance and the adjacent heat source.
• You should check whether there is an electrical socket available, which will be
accessible after your appliance is installed.
• Place the appliance flatly and firmly on a solid base
• Be sure to leave enough space for the opening of the door, to avoid damage to
the appliance or personal injury
• The aperture size has to be a minimum of (H)825 x (W)600 x (D)550mm.
• The accessories that are required for installation are detailed below:
18 x Torx screws
2 x Hinge cover
10
Advertisement
Table of Contents
