Table of Contents
Advertisement
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
Care with turning the fifth wheel upside down is recommended!
Make sure
that the new position will provide ready access to the coupling point
for subsequent removal of the jaw (7).
5)
Remove the traction spring (18);
6)
Pull out the operating handle (19c) fully;
7)
Remove the spring (6) and slip the
jaw out (7). Dispose as specified
in section 9 DISPOSAL
- page 34/36;
8)
Release the jaw (7) from the
lubrication pipe (4);
Insert the new jaw (7) and block it with
9)
the contrast ring pin (2b);
10)
Position in the contrast ring (2c) and lock it on with the two screws (2a) using
some loctite 243 thread-locking compound;
Torque wrench setting for screws (2a)
And (2b): 100-120 Nm.
11)
Anchor the spring (6) onto the
jaw (7) and also insert
lubrication pipe (4);
12)
Unscrew nuts (11c) and (19a) and
slide out the release lever (12);
13)
Remove the wedge (11b) and the
Relative wedge screw (11a). Dispose as
Specified in section 9 - DISPOSAL page 34/36 and
replace accordingly.
14)
Reposition the wedge (11b) and the release lever (12) into the fifth wheel
plate (8);
FIFTH WHEEL Rp10
3
3
1 1
1 1
19c
12
18
18
19a
11c
7
11b
PAG.
31/36
CHAP . 7
REV. 00
4
6
Advertisement
Table of Contents
