Table of Contents
Advertisement
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
2.1 INSTALLATION WITH CARRIER PLATE
Fix the fifth wheel pedestal (15) to the trailer carrier plate using twelve
1)
M16x1.5 screws (property class 8.8) with relative self-locking washers and nuts
unified to 8g class of fit;
Torque wrench setting 200 Nm.
2)
To avoid sheer stress on bolts, support the fifth wheel pedestal (15) by means
of longitudinal and transversal strikers welded onto the fifth wheel carrier
mount plate at an angle bond not less than 5 mm.
N
If unit is installed with flanged screws (property class 10.9) and self-
O
locking nuts (property class 10), striker welding can be avoided.
T
E
Torque wrench setting 270-300 Nm.
30 15
Welded strikers
N
O
Once installation is complete, proceed as instructed in section 2.4
T
- SETTING UP FOR OPERATION - page 13/36.
E
FIFTH WHEEL Rp10
Fifth wheel carrier plate
Truck side chassis
Welded strikers
PAG.
10/36
CHAP . 2
REV. 00
15 30
Advertisement
Table of Contents
