Hide thumbs Also See for 705:

Advertisement

Quick Links

Sean Moroney/Emma Pery 5 Sep 2020
Wisper 705 E-bike Rider's Handbook

Before you start

● You MUST wear an approved cycle helmet when riding your bicycle
● When using any bicycle, it is important that you stay within safe limits; if you
feel as if you are travelling too quickly, you probably are.
● Always test your brakes prior to using the bike and remember the bike will
not stop as quickly in the wet as it would in the dry.
● Do not ride the bike with flat tyres. There is a tyre pump provided with the
E-bike in the pannier
● This E-bike is not designed for offroad use. Please ride on tarmac or even
surfaces only.
Charge ba ery: This can be done with the ba ery s ll inserted in the bike rack. Or if you don't
have a power point near where the bike is stored you can use the key to unlock and slide the
ba ery out to charge indoors. Pressing and holding down the On bu on on top of the ba ery
reveals the charger level.
The charger and cable will be in the pannier when you collect the e-bike: don't leave them there
during your week with the e-bike. Please remove them from the pannier and store the charger
and cable in a safe place at home .
The e-bike key locks the ba ery to the bike and is not needed to operate the bike's electrical
system.
The ba ery is connected to the electrical system of the bike automa cally when you slide
the ba ery into the rack. To turn on the bike's electrical system, press I on the switch located on
1
E-Bike Rider's Handbook doc no. 07

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 705 and is the answer not in the manual?

Questions and answers

Summary of Contents for Wisper 705

  • Page 1 Sean Moroney/Emma Pery 5 Sep 2020 E-Bike Rider’s Handbook doc no. 07 Wisper 705 E-bike Rider’s Handbook Before you start ● You MUST wear an approved cycle helmet when riding your bicycle ● When using any bicycle, it is important that you stay within safe limits; if you feel as if you are travelling too quickly, you probably are.
  • Page 2 Sean Moroney/Emma Pery 5 Sep 2020 E-Bike Rider’s Handbook doc no. 07 the right-hand side at the rear of the ba ery. To turn off the power, press 0. Fig 2 When the ba ery has been turned on, the bike is ready for use. The on/off bu on of the handle bar control isolates the power from the bike.
  • Page 3 The display also incorporates a diagnos c func on for use by Wisper service. Lights: The LIGHT bu on is the on/off bu on . If you click the on/off when the bike’s power is on, the LED headlight and rear light will illuminate.
  • Page 4 Sean Moroney/Emma Pery 5 Sep 2020 E-Bike Rider’s Handbook doc no. 07 The ba ery capacity indicator gives an approxima on of ba ery capacity remaining. Each bar on the LCD approximates to a ¼ of the capacity. However, this indicator relies on sensing ba ery voltage that will rise and fall depending on the amount of power being demanded at any given me, the meter should only be used for indica on purposes.
  • Page 5 Sean Moroney/Emma Pery 5 Sep 2020 E-Bike Rider’s Handbook doc no. 07 Adjust the seat to the correct height and close the lever firmly. When you sit on the saddle there should be no ver cal movement. Never apply grease to the seat post . Bike Stand On the le hand side.

Table of Contents