Advertisement
Using Kettle with Pre-set Temperature
You can select a pre-set temperature using the temperature buttons. There are "70°C" or
"80°C" and "90°C" for selection.
1.
Select a pre-set temperature, its corresponding indicator light is turned on.
2.
Press the power button, the kettle starts heating.
3.
When boiling the water to the pre-set temperature, a beep can be heard. The
kettle will stop heating and enter keep-warm mode automatically.
4.
The kettle will keep the water warm for 30 minutes. The indicator lights of the
selected temperature button, the keep warm button and light bar are turned on
during this process.
5.
After this process, all the indicator lights are turned off and the kettle enters sleep
mode. Press any button to make the kettle enter standby mode.
6.
Lift the kettle from the power base and then pour the water.
Note:
Operate carefully when pouring the water from your kettle as boiling water may
result in scalding. Do not open the lid while the water in the kettle is hot.
Pre-set Temperature Tips
•
The kettle will reheat the water to the pre-set temperature and then stop heating if
the water temperature is 5°C lower than the pre-set temperature during keeping
warm process. For example, if the pre-set temperature is 70°C, the kettle will reheat
the water to 70°C and then stop heating if the water temperature is lower than
65°C during keeping warm process.
•
You can press the power button or keep warm button to stop the kettle from
keeping the water warm during keeping warm process.
•
Under keeping warm condition, remove the kettle from the power base for more
than 3 minutes, then replace the kettle on the power base, the kettle will continue
to keep the water warm based on the pre-set temperature.
General Tips
•
Hold and press the power button for 2 seconds, the kettle will enter sleep mode.
Press any button to make the kettle enter standby mode.
•
The kettle may be stored on the power base when not in use.
•
Always disconnect the power supply when not use.
Advertisement
