Advertisement
Before Using Your Kettle
If you are using the kettle for the first time, it is recommended that you should clean your
kettle before use by boiling the Max capacity of water once and then discarding the water
twice. Wipe the surface with a damp cloth.
The maximum capacity of this kettle is 1.7 litres.
Using Kettle to Boil Water
1.
Place the kettle and power base on a flat surface.
2.
To fill the kettle, remove it from the power base and open the lid by pressing down
lid release button, then fill the kettle with the desired amount of water and close
the lid. The water level must be within the Min and the Max level. Too little water
will cause the kettle switching off before the water has boiled.
Note:
Do not fill the water over the 'maximum' line, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before plugging the power
outlet.
3.
Plug into the power outlet, the light bar blinks.
4.
Position the kettle on the power base, the light bar, and the 100°C button indicator
light is turned on.
5.
If you do not want to select a pre-set temperature, you can press power button
directly, then the kettle starts heating and it will boil the water to 100°C. During the
heating process, the indicator lights of the 100°C button, the power button and the
light bar is turned on.
6.
After heating, a beep can be heard. The kettle will stop working automatically.
Boiling Tips
•
You can press the power button to stop the kettle during heating process.
•
The kettle will enter sleep mode if you remove the kettle from the power base or no
operation for more than 3 minutes during heating process. Replace the kettle on
the power base and press any button, then the kettle will enter standby mode.
Advertisement
