Download Print this page
Wolverine Airsoft STORM Owner's Manual

Wolverine Airsoft STORM Owner's Manual

Ontank/highpressure
Hide thumbs Also See for STORM:

Advertisement

Quick Links

Page 1
OnTank / HighPressure
OWNER'S MANUAL
WOLVERINE AIRSOFT
www.wolverineairsoft.com
www.wolverineairsoft.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the STORM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Wolverine Airsoft STORM

  • Page 1 Page 1 OnTank / HighPressure OWNER’S MANUAL WOLVERINE AIRSOFT www.wolverineairsoft.com www.wolverineairsoft.com...
  • Page 2 Getting Started Installation / Use / Tournament Lock InGrip Installation / Use Maintenance Don’t Forget to Register Your Warranty! Your STORM Regulator is backed by Wolverine Airsoft’s limited warranty. Scan the QR code or visit www.wolverineair- soft.com/warranty to read our full warranty and register your STORM Regulator.
  • Page 3 2. The STORM InGrip regulator is designed for use with a standard paintball style remote line. Tradition- al HPA lines used for airsoft ARE NOT RATED FOR HIGH PRESSURE between the tank and regulator.
  • Page 4 Page 4 Getting Started The Wolverine Airsoft STORM OnTank and STORM InGRIP regulators are intended for use with standard pressure or low pressure paintball HPA tanks. The InGrip regulator can also be used with standard CO2 tanks. Pressure is adjusted by turning the set screw on the front of the reg- ulator using the included 3/32”...
  • Page 5 Page 5 STORM OnTank/HighPressure Installation To install the regulator, simply thread the regulator onto the top of your HPA tank. Screw the regulator all the way down until it stops. The final ½-¾ turn will open valve on the tank regulator to pressurize the system.
  • Page 6 Page 6 STORM OnTank/HighPressure Installation To install the STORM InGrip regulator remove the stock airline from the back of your Wolverine Airsoft HPA engine using a 5/16” wrench. Install the airline with the ¼” macro line onto the engine and reinstall engine and gearbox in the gun.
  • Page 7 Page 7 Maintenance Your STORM regulator is designed to require very little maintenance. However if you feel the regulator is in need of lubrication you can disassemble by removing the three flat head screws from the side of the regulator. Use TechT Gun Sav or another O-ring safe lubricant on all o-rings and reassemble.
  • Page 8 Need professional help? To find a retailer close to you visit: www.wolverineairsoft.com/dealers www.wolverineairsoft.com...