WaterUps Oasis 1240 Quick Start Manual

Assembly of the Water Reservoir and Cells
Watch the full assembly video for assembling the water reservoir
on our website:
www.waterups.com.au/product/waterups-oasis-1240-wicking-bed
1: Take the liner and fold the ends as shown in the video.
2: Push the three tabs in the corners from the outside in and repeat
the entire process for the next three corners, creating the square
base liner.
3: Place the liner inside the planter, make sure the hole in the liner
and the hole in the planter match up.
4: Take one of your cells and the overflow pipe and assemble as
shown in the video.
5: Feed the cell and the overflow pipe through the hole in the
reservoir and the planter and ensure it sits flat in the bottom of the
reservoir. Replace the spacer on the overflow pipe and tighten the
nut.
6: Take another cell the inlet pipe. With a sharp knife remove the
circle in the cell along the line as indicated in the video.
7: Insert the inlet pipe into the cell. Take note of the three tabs on
the inlet pipe that will fit through the three holes in the cell. Apply
some pressure until it clicks in.
8: Insert this cell in the end of the planter. Decide if you want the
inlet at the side or back.
9: Then take the last cell and place it in the middle.
Filling your Planter
For suggestions about soil for wicking beds and other relevant
information visit our website.
This information booklet is printed on recycled paper.
Please compost or recycle this when you are finished.
Oasis 1240
Self-Watering Wicking Bed Kit
Before you start
Watch the full assembly video for your Self-Watering
Wicking Bed Kit on the Waterup Website.
www.waterups.com.au/product/waterups-oasis-1240-wicking-bed
www.waterups.com.au | Email: sales@waterups.com.au | Phone: 1300 205 550
by
Scan the
QR Code to go
to the website