WaterUps
This guide is designed to assist you with the assembly of your new WaterUps
What is in the kit?
The following items should be included:
1. 4 x Le�-side Bracket Side Rails
2. 4 x Right-side Bracket Side Rails
3. 4 x Joiner Inserts
4. 3 x Corner Panels
5. 1 x Corner Panel with the hole for
the overflow pipe
6. 4 x End Rails
7. 6 x Wall Panels
8. 1 x bag of screws
9. 8 x WaterUps
®
Wicking Cells
10.1 x WaterUps
®
1680 Reservoir Liner
11.1 x WaterUps
®
Black Inlet Pipe & Cap
12.1 x WaterUps
®
Overflow Pipe Set
(screw pipe fi�ng, washer, spacer
pipe and nut)
Oasis 1680 wicking bed assembly guide
®
Assembly Instruc�ons
1. Check that you have all of the
components listed above.
2. Peel the protec�ve plas�c off the
rails and corner panels.
3. Join 1 x le�-side and 1 x right-side
bracket rail to 1 x end rail and screw
in the 4 x self-tapping screws to
secure the rails. You should now
have a U-shaped rail.
Figure 1. Both U-shaped bo�om rail
sec�ons being joined together using the
joiner inserts.
4. Repeat to create a second U-shaped
rail.
5. Join the 2 x U-shaped rails using the
Joiner Inserts to form the base for
the Oasis bed as shown in Figure 1.
Adjust the posi�on of the inserts so
that the screw holes align and screw
in the 4 x self-tapping screws.
6. Now turn the connected U-shaped
rails over so that you can see the
channel for the corner and wall
panels. Locate the corner panel with
®
Oasis 1680 wicking bed kit.
Figure 2. The first end wall is complete
with the top rail in place.
the hole for the overflow pipe and
posi�on it in the base with the hole
closest to the bo�om. Align the
screw hole in the corner panel and
the matching hole in the rail and
insert the self-tapping screw to
secure.
Figure 3. Securing the top rail to the wall
panels, with the joiner insert in place.