WaterUps Oasis 1240 Assembly Manual

WaterUps
This guide is designed to assist you with the assembly of your new WaterUps
What is in the kit?
The following items should be included:
1. 4 x short end rails with corner
brackets
2. 4 x long side rails
3. 1 x end sec�on
4. 1 x end sec�on with hole for the
overflow pipe
5. 2 x 760mm long wall panels
6. 2 x 380mm short wall panels
7. 1 x bag of screws
8. 3 x WaterUps ® Wicking Cells
9. 1 x WaterUps ® 1240 Reservoir Liner
Insert
10. 1 x WaterUps ® Inlet Pipe & Cap
11. 1 x WaterUps ® Overflow Pipe Set
(screw pipe fi�ng, washer, spacer
pipe and nut)
Oasis 1240 wicking bed assembly guide
®
Assembly Instruc�ons
1. Check that you have all of the
components listed in column one.
2. Peel the protec�ve plas�c off the
rails and end sec�ons.
3. Join 2 end rails with corner brackets
using the long side rails and insert
screws to form the base of the bed
frame.
Figure 1. This image shows the end
sec�on with the hole for the overflow
pipe.
4. Now locate the end sec�on with the
hole for the overflow pipe, as shown
in Figure 1, and insert it into the rail
with the hole for the overflow pipe
posi�oned closest to the rail. Align
the screw hole in the end sec�on
and the matching hole in the rail and
insert screw to secure.
® Oasis 1240 wicking bed kit.
Figure 2. The front wall panels and the
top rails need to be added to complete
the walls of the Oasis 1240 wicking bed.
5. Repeat for the other end sec�on.
6. Add 1 short and 1 long wall panel to
each side of the bed.
7. A�ach the remaining 2 x long side
rails to the remaining end rail and
insert screws.
8. Carefully push the end rail into
posi�on on the end sec�on and start
to push the long side rails onto the
wall panels. Note: this should be a
reasonably �ght fit. Be careful with
any sharp edges.
9. Once in posi�on screw the top rails
to the end panel as you did with the
bo�om rail.
10. Now add the remaining end rail and
screw into posi�on.