Functional Description - Makita 3711 Instruction Manual

FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Adjusting trimmer bit protrusion
To adjust the bit protrusion, loosen the clamping screw
and move the base up or down as desired by turning
the adjusting screw. After adjusting, tighten the clamp-
ing screw firmly to secure the base.
3
► 1. Base 2. Scale 3. Bit protrusion 4. Clamping screw
5. Adjusting screw
Switch action
CAUTION:
Before plugging in the tool, always
be sure that the tool is switched off.
To start the tool, move the switch lever to the I position.
To stop the tool, move the switch lever to the O position.
► 1. Switch lever
1
5
2
Electronic function
The tool is equipped with the electronic functions for
easy operation.
Indication lamp
► 1. Indication lamp
The indication lamp lights up green when the tool is
plugged. If the indication lamp does not light up, the
4
mains cord or the controller may be defective. The indi-
cation lamp is lit but the tool does not start even if the
tool is switched on, the carbon brushes may be worn
out, or the controller, the motor or the ON/OFF switch
may be defective.
Unintentional restart proof
The tool does not start with the switch lever in I position
even when the tool is plugged.
At this time, the indication lamp blinks in red and shows
the unintentional restart proof device is on function.
To cancel the unintentional restart proof, return the
switch lever to O position.
Soft start feature
Soft-start feature minimizes start-up shock, and makes
the tool start smoothly.
ASSEMBLY
CAUTION:
switched off and unplugged before carrying out
any work on the tool.
1
Installing or removing trimmer bit
CAUTION:
out inserting a trimmer bit, or the collet cone will
break.
CAUTION:
with the tool.
5 ENGLISH
Always be sure that the tool is
Do not tighten the collet nut with-
Use only the wrenches provided
1