Polk Mono React Service Manual page 36

4. Locale settings and confirmation
4.1. Creating the locale settings and confirmation file
(1) Click [Start button] - [Accessories] - [notepad] on the PC to launch the notepad.
(2) Enter "TEXT".
(3) Click "File", and then click "Save As...".
(4) Enter the file name "avs-config-locale-XXX" and click the Save button.
NOTE : Enter the file name in double quotation marks. (The file extension is not required.)
Locale File name
Confirmation Locale Confirmation "avs-config-locale-get"
North America "avs-config-locale-set-1"
Europe "avs-config-locale-set-2"
Change
Japan "avs-config-locale-set-3"
Australia "avs-config-locale-set-4"
(5) Copy the files created on the USB flash drive.
4.2. Locale confirmation
(1) Insert the AC plug and turn on the power.
• Do not connect anything to the unit.
(2) After the unit finishes starting up, insert the USB flash drive. (avs-config-locale-get)
(3) The status LED blinks in purple to indicate the locale.
North America
Europe
Japan
Australia
(4) Remove the USB flash drive device.
• The light bar turns blue, and the unit restarts.
(5) After the unit finishes restarting, remove the AC plug.
4.3. Locale setting change
(1) Insert the AC plug and turn on the power.
• Do not connect anything to the unit.
(2) After the unit finishes starting up, insert the USB flash drive. (avs-config-locale-set-X)
• X : 1=North America, 2=Europe, 3=Japan, 4=Australia
(3) The status LED lights up in green for approximately 5 seconds.
• This indicates that the locale settings are complete.
(4) The status LED blinks in purple to indicate the locale.
North America
Europe
Japan
Australia
(5) Remove the USB flash drive device.
• The light bar turns blue, and the unit restarts.
(6) After the unit finishes restarting, perform a factory reset.
• See
copy to USB flash drive
(7) Remove the AC plug.
36
Locale Blinking
Blinking x 1 -> Off(1sec)
Blinking x 2 -> Off(1sec)
Blinking x 3 -> Off(1sec)
Blinking x 4 -> Off(1sec)
Locale Blinking
Blinking x 1 -> Off(1sec)
Blinking x 2 -> Off(1sec)
Blinking x 3 -> Off(1sec)
Blinking x 4 -> Off(1sec)
"Initializing this Unit"