Page 1
Your life and the lives of others depend on it! Cover photo may show optional equipment not supplied with standard unit. For an Operator’s Manual and Decal Kit in French Language, please see your Land Pride dealer. Printed 3/2/22...
Machine Identification Record your machine details in the log below. If you replace this manual, be sure to transfer this information to the new manual. If you, or the dealer, have added Options not originally ordered with the machine, or removed Options that were originally ordered, the weights and measurements are no longer accurate for your machine.
Page 3
Land Pride assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Land Pride reserves the right to revise and improve its products as it sees fit. This publication describes the state of this product at the time of its publication, and may not reflect the product in the future.
Page 4
Parts Manual for this link you to available dealers equipment. Download the appropriate for Land Pride products. App on your smart phone, open the App, Refer to Parts Manual QR point your phone on the QR code and Locator on this page for take a picture.
Important Safety Information Important Safety Information Listed below are common practices that may or may not be applicable to the products described in this manual. Safety at All Times Look for the Safety Alert Symbol Careful operation is your best The SAFETY ALERT SYMBOL indicates there is a potential hazard assurance against an accident.
Page 6
Replace parts on this implement using the correct tools and follow all shutdown procedures equipment. with genuine Land Pride parts only. before leaving the operator’s seat to Do not alter this implement in a way Always properly match the wheel perform maintenance.
Use Seat Belt and ROPS Keep Riders Off Lights and Devices Machinery Land Pride recommends the use of a CAB or roll-over-protective- A Slow moving power machine Never carry riders on the tractor or structures (ROPS) and seat belt can create a hazard when driven implement.
Page 8
Important Safety Information Listed below are common practices that may or may not be applicable to the products described in this manual. Avoid crystalline Silica Be aware of and follow OSHA If possible, change into disposable (or other local, State, or Federal) or washable work clothes at the (quartz) Dust guidelines for exposure to airborne...
Page 9
Important Safety Information This page left blank intentionally. 3/2/22...
Spray soapy water onto the cleaned area. all damaged or missing labels. Order new labels from your Peel backing from label and press label firmly onto the nearest Land Pride dealer. To find your nearest dealer, surface. visit our dealer locator at www.landpride.com.
Page 11
Table of Contents Important Safety Information 23770 70358 Reference RTR0542 & RTR0550 (Shown) 23771 818-543C Danger: Guard Missing Hazard - Do not Operate 1 Place 70375 23760 818-552C Danger: Rotating Driveline - Keep Away 1 Place 70374 23760 818-540C Danger: Guard Missing - DO NOT Operate 1Place 3/2/22 RTR0542 &...
Figure 1. Application The RTR05 Series Reverse-Till Rotary Tillers are designed and built by Land Pride to till soil for seedbed or planting preparation. The RTR05 Series tillers are adapted for tractors with 540 rpm power take-off speed and Category I 3-Point hitch on tractors in the 17-26 hp (12.7-19.4 kW) range.
Table of Contents Section 1: Assembly & Set-Up Section 1: Assembly & Set-Up Dealer Preparations WARNING To avoid serious injury or death: WARNING Lightweight tractors with rear attached implements may need To avoid serious injury or death: weights added to the front to maintain steering control. An unsupported parked tiller can tip over easily.
Table of Contents Section 1: Assembly & Set-Up 23772 Hitch, Park Stand and Driveline Assembly Figure 1-1 Park Stand Adjustment 3-Point Hitch Assembly Refer to Figure 1-1: Refer to Figure 1-1: Attach 3-Point hitch Assembly (#2) to inside of hitch WARNING plates with four 1/2 -13 x 1 1/2...
Table of Contents Section 1: Assembly & Set-Up Driveline Installation 23793 Implement End IMPORTANT: The driveline must be lubricated before putting it into service. Refer to “Lubrication Points” on page 25. Pull Collar Yoke Refer to Figure 1-2 & Figure 1-3: Push Pin Yoke The driveline is coupled to the implement’s gearbox input Shear Bolt Clutch...
Table of Contents Section 1: Assembly & Set-Up NOTE: Land Pride’s Quick Hitch can be attached to the tractor to provide quick and easy 3-point hook- up and detachment. See your nearest Land Pride dealer to purchase a Quick-Hitch. Stabilize lower 3-Point arms to prevent side-to-side movement.
Table of Contents Section 1: Assembly & Set-Up WARNING To avoid serious injury or death: • Always follow “Tractor Shutdown Procedure” provided in this manual before dismounting the tractor. • Select a safe ground speed that will allow adequate control of steering and stopping.
Table of Contents Section 1: Assembly & Set-Up 22311 22311 22311 Check Driveline Minimum Length Shorten Driveline Length Figure 1-7 Figure 1-8 Refer to Figure 1-8: Check Driveline Collapsible Length 8. Shorten driveline as follows: IMPORTANT: A driveline that is too long can bottom a.
Table of Contents Section 1: Assembly & Set-Up 5. Check to make sure the driveline does not exceed 24872 any of the limits listed below: • Center of lower 3-point hitch pins do not exceed 21" (53 cm) above ground level. •...
Table of Contents Section 2: Operating Section 2: Operating Operating Checklist Safety Information Hazard control and accident prevention are dependent DANGER upon the awareness, concern, prudence and proper training involved in the operation, transport, maintenance To avoid serious injury or death: •...
Page 21
Table of Contents Section 2: Operating Transporting WARNING To avoid serious injury or death: WARNING • Always disengage power take-off immediately after lifting To avoid serious injury or death: tiller above ground level. Never operate tiller in the raised • When traveling on public roads, use LED lights, slow position.
Page 22
Table of Contents Section 2: Operating Pull back on the driveline pull collar and hold while 23776 pulling the driveline yoke from the tractor’s power take-off shaft. 8. Collapse driveline by pushing tractor end of driveline towards the tiller. Store yoke end off the ground to keep it out of the trash and dirt.
With a little practice and a few adjustments, you will soon disengaging power take-off, turning off tractor be achieving the results you want with your Land Pride 05 engine, and removing ignition key. Series Reverse Tine Rotary Tiller. See “Features and Benefits”...
Table of Contents Section 3: Adjustments Section 3: Adjustments 3-Point Hitch Adjustment Skid Shoe Adjustment Park tractor and tiller on a flat level surface. Refer to Figure 3-2: The skid shoes can be adjusted to the desired tilling 2. Slowly raise tiller with hydraulics until the tines are depth by raising or lowering them as follows: about 1"...
Table of Contents Section 4: Maintenance & Lubrication Section 4: Maintenance & Lubrication Maintenance Remove Driveline Proper servicing and adjustments are key to the long life It will be easier if the driveline is removed from the tractor of any implement. With careful inspection and routine and tiller while replacing a shear bolt or repairing the slip maintenance, you can avoid costly downtime and repair.
“Remove Driveline” on page 21. operation and after long periods of inactivity to remove 2. Replace shear bolts with genuine Land Pride shear any oxidation that may have accumulated on friction bolts. Install a new shear bolt in the push pin yoke surfaces.
Page 27
Table of Contents Section 4: Maintenance & Lubrication 24501 35965 IMPORTANT: Measured and record length “A” of each spring before disassembling the clutch. Use 1 11/32" (34 mm) for “A” dimension if measurements were not taken before disassemble. Spring Length Figure 4-4 23844 Slip Clutch Run-In...
4. Repaint parts where paint is worn or scratched to prevent rust. Ask your dealer for Aerosol Land Pride touch-up paint. They are also available in touch-up bottles with brush, quarts, and gallon sizes by adding TU, QT, or GL to the end of the Aerosol part number.
Table of Contents Section 4: Maintenance & Lubrication 23770 Bearing On Right End Of Rotor Shaft Type of Lubrication: Multi-Purpose Quantity = As Required 23780 Required Gearbox Check oil every 50 hours of operation. Check oil level in gearbox by removing the center plug at the rear of the box.
Page 31
#80 Roller chain - Fully enclosed in oil bath with drain and fill plugs Shell Gadus S2 V2200 00 flowable grease or equivalent Drive chain lubrication oz (L) Land Pride Part #821-045C (32 oz. or .95L bottle) Sprockets Case hardened teeth, splined bores Rotor swing diameter...
For deep soil penetration. Clevis lower hitch Provides additional strength and easy one person hook-up. Allows for quick and easy one person hook-up. Fits Land Pride Quick Hitch An additional driveline may be required. Adjustable park stand Allows for easy hook-up and storage.
Table of Contents Section 6: Features & Benefits Section 6: Features & Benefits Trouble Shooting Chart Problem Cause Solution Tines are loose. Tighten tines. Implement makes Gearbox has tooth damaged. Replace damaged gearbox. intermittent clicking noise Roller chain is damaged. Replace damaged chain link.
Table of Contents Section 7: Troubleshooting Section 7: Troubleshooting Torque Values Chart for Common Bolt Sizes Bolt Head Identification Bolt Head Identification 10.9 Bolt Size Bolt Size (inches) Grade 2 Grade 5 Grade 8 (Metric) Class 5.8 Class 8.8 Class 10.9 in-tpi N ·...
This Warranty is limited to the repair or replacement of any defective part by Land Pride and the installation by the dealer of any such replacement part, and does not cover common wear items such as blades, belts, tines, etc. Land Pride reserves the right to inspect any equipment or parts which are claimed to have been defective in material or workmanship.
Need help?
Do you have a question about the RTR05 Series and is the answer not in the manual?
Questions and answers