Download
Share
Print this page
KAMA AD 105S Instruction Manual
  1. Manuals
  2. Brands
  3. KAMA Manuals
  4. Saw
  5. AD 105S
  6. Instruction manual

KAMA AD 105S Instruction Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Elderfield & Hall, Inc.,
www.kooltools.com
10901 McBride Lane
Knoxville, Tn 37932
T: 865.671.7682 Fax: 865.671.7686
Email: bob@kooltools.com
Kama Bandsaw AD 105S
110 Volt, Single Phase
2 ¼ HP Portable Benchtop Bandsaw
For Accurate Cuts Up to 4".
Instruction Manual:
Introduction to the Manual
General Precautions
Equipment
Machine
Start-Up
Caution
Maintenance

Advertisement

loading

Related Manuals for KAMA AD 105S

Summary of Contents for KAMA AD 105S

  • Page 1 Elderfield & Hall, Inc., www.kooltools.com 10901 McBride Lane Knoxville, Tn 37932 T: 865.671.7682 Fax: 865.671.7686 Email: bob@kooltools.com Kama Bandsaw AD 105S 110 Volt, Single Phase 2 ¼ HP Portable Benchtop Bandsaw For Accurate Cuts Up to 4”. Instruction Manual: Introduction to the Manual...

  • Page 2: Introduction To The Manual

    1. Introduction to the Manual 2. General Precautions Always make sure in advance that the minimum  The purpose of this manual is to provide the safety, placement and operating standards are necessary information for competent, safe use of respected, taking note of the environmental the equipment.
  • Page 3 3. Equipment 4. Machine The benchtop band saw is supplied ready to use, packed in a cardboard box and protected by a sheet 4.1 Identification The essential information for identifying the of cardboard. machine is found on the plates located outside the product.
  • Page 4 4.3 Components (Refer to fig. 2) 4.6 Lifting and Moving The saw may be lifted, carried and moved by hand in compliance with the instructions below: Base  Safety / Shipment fasten the blade arm in its end position using the Vise Crank mechanical lock provided (fig.
  • Page 5 5.2 Cutting Speed (FPM) 6. Caution (Dial Speed is measured in Meter per Minute) Stainless Steel: 65-163 20-50 Copper, Aluminum The first time it is started, the machine will be fairly and its Alloys: 163-260 50-79 noisy, due to the normal breaking-in stage of the Steel, etc.: 260-357 79-109...

  • Page 6: Maintenance

    7. Maintenance 7.2 After Each Working Shift 7.1 Replacing the saw Carefully clean all parts of the machine, to remove It is essential to wear protective gloves shavings and cutting residue. when changing the blade.  Remove the corner plate (27) from the sliding 7.3 Periodically blade guide.
  • Page 7 fig. 2A fig. 2B fig. 2 fig. 2C fig. 4 fig. 3 fig. 5 fig. 6...
  • Page 8 KAMA AD 105S BANDSAW PURCHASED ON: _____________________________________ PURCHASED FROM: __________________________________ NOTES: __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ __________________________________________________________________________ Elderfield & Hall, Inc., Distributed By: www.kooltools.com 10901 McBride Lane Knoxville, TN 37932 T: 865.671.7682 Fax: 865.671.7686 Email: bob@kooltools.com...