Page 1
Elderfield & Hall, Inc., www.kooltools.com 10901 McBride Lane Knoxville, Tn 37932 T: 865.671.7682 Fax: 865.671.7686 Email: bob@kooltools.com Kama Bandsaw EV88 115 Volt, Single Phase 2 ¼ HP Portable Benchtop Bandsaw For Accurate Cuts Up to 6”. Instruction Manual: Introduction to the Manual...
1. Introduction to the Manual 2. General Precautions Always make sure in advance that the minimum " The purpose of this manual is to provide the safety, placement and operating standards are necessary information for competent, safe use of respected, taking note of the environmental the equipment.
Page 3
3. Equipment 4. Machine 4.1 Identification band saw is supplied ready to use, packed in a cardboard box and protected by a sheet The essential information for identifying the of cardboard. machine is found on the plates located outside the product.
4.3 Components (Refer to fig. 2a - 2c) 4.6 Lifting and Moving The saw may be lifted, carried and moved by hand in compliance with the instructions below: 1Base " fasten the blade arm in its end position using the 2Vise Crank mechanical lock provided;...
Page 5
5.2 Cutting Speed (FPM) 6. Caution (Dial Speed is measured in Meter per Minute) Stainless Steel: 65-163 20-50 Copper, Aluminum The first time it is started, the machine will be fairly and its Alloys: 163-260 50-79 noisy, due to the normal breaking-in stage of the Steel, etc.: 260-357 79-109...
7. Maintenance 7.2 After Each Working Shift 7.1 Replacing the saw blade Carefully clean all parts of the machine, to remove It is essential to wear protective gloves when changing the blade. shavings and cutting residue. " Remove the corner plate (A) from the sliding 7.3 Periodically blade guide.