Button Operations - Huawei R100020G1 User Manual

R100020G1 Charging Module
User Manual
Display
Mode
Status code
Table 2-5 Status code mapping
Status
Code
H00
H01
H02
H03
H04
H05
H06
H07

2.4.4 Button Operations

The buttons allow you to set the output voltage, output current, hardware
address, and group number, and to start or shut down the charging module.
●
●
Issue 05 (2021-11-16)
Description
● Auo is displayed by default in standard mode. The
● dEG indicates the setting mode.
● The Auo and dEG modes can be switched using
● The high-order character is displayed as H, and the
● Parameters cannot be set using buttons.
Status Description
Default status
Silent mode
Input derating
Temperature derating
Air filter blocked
Manual switching mode
250 kbps baud rate
Customer version configuration mode
Press the left button (for at least 0.25s) to turn the displayed screen or switch
the high-, middle-, and low-order nixie tubes.
Press the right button (for at least 0.25s) to turn the displayed screen or
increase or decrease digits.
Copyright © Huawei Digital Power Technologies Co., Ltd.
charging module works under the system monitoring
command.
1. The output voltage, output current, and startup/
shutdown can be set only in this mode. The settings
become invalid upon mode exiting.
2. The charging module can run properly without
being connected to the system monitoring module.
buttons.
middle- and low-order characters are displayed as
digits.
2 Overview
13