Progress PV1548 User Manual page 20

20 Progress
Problem and alarm code
The temperature of the water inside
the appliance is too high or malfunction
of the temperature sensor occurred.
• The indicator
termittently.
• Acoustic signal sounds 6 times in‐
termittently.
Technical malfunction of the appliance.
• The indicator
intermittently.
• Acoustic signal sounds 12 times in‐
termittently.
The level of water inside the appliance
is too high.
• The indicator
intermittently.
• Acoustic signal sounds 15 times in‐
termittently.
The appliance stops and starts more
times during operation.
The programme lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
The appliance door opens during the
wash cycle.
Rattling/knocking sounds from inside
the appliance.
The appliance trips the circuit-beaker.
flashes 6 times in‐
flashes 12 times
flashes 15 times
Possible cause and solution
• Make sure that the temperature of the inlet wa‐
ter does not exceed 60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the
right height above the floor. Refer to the installa‐
tion instructions.
• It is normal. It provides optimal cleaning results
and energy savings.
• Refer to the consumption values table in the
chapter "Programmes".
• The appliance is not levelled. Loosen or tighten
the adjustable feet (if applicable).
• The appliance door is not centred on the tub.
Adjust the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten
the adjustable feet (if applicable).
• Parts of the tableware are protruding from the
baskets.
• The AirDry function is activated. You can deacti‐
vate the function. Refer to "Settings".
• The tableware is not properly arranged in the
baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simulta‐
neously all the appliances in use. Check the
socket amperage and the capacity of the meter
or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact
an Authorised Service Centre.