Cleaning Chart - Frigidaire 318200760 Use & Care Manual

Cleaning the Cooktop, Burner Heads, Caps & Grates
The cooktop is designed to make cleaning easier. Because the gas Burners are sealed, cleanups are easy when spillovers are
cleaned up immediately.
The cooktop, Burner Heads and Caps should be routinely cleaned. Keeping the Burner Head Ports clean will prevent improper
ignition and an uneven flame. Refer to the following instructions:
THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.
THE FIXED OVEN VENT IS NOT REMOVABLE. Do not attempt to remove the fixed oven vent cover.
Use caution when replacing the Burner Caps so the Electrodes are not damaged. This may cause a delayed
ignition or prevent the burner from igniting.
1st
Surface
Burner
Grate
2nd
3rd
Electrode
Orifice
holder
Figure 1
Ceramic Glass Cooktop Cleaning and Maintenance
Consistent and proper cleaning is essential to maintaining your ceramic glass cooktop
Prior to using your cooktop for the first time, apply some of the cooktop cleaning cream supplied with your range. Buff with a
non-abrasive cloth or pad (such as a 3M Scotch-Brite® Blue Multi-Purpose No Scratch Scrub Sponge). This will make cleaning
easier when soiled from cooking. The special cooktop cleaning cream leaves a protective finish on the glass to help prevent
scratches and abrasions.
Sliding aluminum or copper clad bottom pans on the cooktop can cause metal markings on the cooktop surface. These
marks should be removed immediately after the cooktop has cooled using the cooktop cleaning cream. Metal marks can
become permanent if not removed prior to future use.
Cookware (cast iron, metal, ceramic or glass) with rough bottoms can mark or scratch the cooktop surface. Do not slide
anything metal or glass across the cooktop. Do not use your cooktop as a cutting board or work surface in the kitchen.
Do not cook foods directly on the cooktop surface without a pan. Do not drop heavy or hard objects on the glass cooktop,
they may cause it to crack.
Care & Cleaning

(Cleaning Chart)

To Remove and Replace the Surface Burner Caps and Burner Heads - Remove in
the following order: (1st) surface Burner Grates, (2nd) Burner Caps and (3rd) Burner
Heads. Replace in the following order: Burner Heads, Burner Caps and Burner Grates.
Do not remove any parts from the cooktop until they have completely cooled and
are safe to handle. Do not operate the surface Burners without the Burner Caps and
Burner Heads properly in place.
To Clean the surface Burner Caps and Burner Heads (all models)- Use a soap-filled
scouring pad or a mild abrasive cleanser to clean the surface Burner Caps and Burner
Heads. The ports (or slots) around the Burner Heads must be routinely cleaned. If
Surface
residue still remains in these ports, use a small-gauge wire or needle to clean the slots
Burner
or holes. For proper flow of gas and ignition of the burner—DO NOT ALLOW SPILLS,
Cap
FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING. ALWAYS keep the surface Burner Caps and Burner
Heads in place whenever the gas Burners are in use.
Surface
Burner
To Clean the Burner Grates- The Burner Grates are dishwasher safe and may be
Head
cleaned in the dishwasher. Remove any excessive soils before placing in the
dishwasher.
To Clean the Ceramic Glass Cooktop- See Ceramic Glass Cooktop Cleaning &
Maintenance later in this section.
15