Table of Contents
Advertisement
WARRANTY VALIDATION FIELD START-UP REPORT
CUSTOMER:_________________________________
BURNER MODEL: ____________________________ BOILER MODEL: ________________________________
CONTROL CIRCUIT COMPONENT OPERATIONAL TESTING (Check if Okay)
Primary LWCO _______________ High Limit ____________________ Firing Rate Control __________________
Secondary LWCO _____________ Operational Control ____________ Low Fire Start Switch ________________
High Gas Press. Switch _________ Oil Press. Switch ______________ High Fire Purge Switch _______________
Low Gas Press. Switch _________ Air Flow Switch _______________ Other _____________________________
FIELD
COMBUSTION SETTINGS
Firing Rate
Primary Gas Pressure
Secondary Gas Pressure
CO
2
O
2
Smoke or CO (ppm)
NOx (ppm)
o
Stack Temp. Net
F
o
Room Temperature
F
Overfire Draft " WC
Breeching Draft " WC
o
Water Temp.
F/Steam Press.
Air Inlet Shutter (" Open)
Flame Signal Pilot
Flame Signal Main
Oil Noz. Press/Man. Gas Pres.
By-Pass Oil Pressure
Atomizing Air Pressure
Combustion Efficiency
Running Motor Amps & Volts
Comments:
Having read the Manufacturer's service manual as to the proper installation, start-up and service of the unit above, I
verify that the burner has been put into operation as specified, and that the above information and checks are com-
plete and correct.
START-UP BY _______________________________________________ Date _________________________
Company ___________________________________________ Phone No. ____________________________
Address ___________________________________________________________________________________
NOTE: Warranty Validation - Field Start-up report must be completed, signed, dated and the top copy sent to
Webster Combustion, Winfield, KS 67156, to validate equipment warranty.
SC Manual
OIL FIRED
Low
Med.
L1
Page 31
High
Low
L2
W.O. _________________
GAS FIRED
Med.
High
L3
Warranty Validation - Form #113
Advertisement
Table of Contents
