Table of Contents
Advertisement
4 Disassembly/Assembly procedures
4.1.
Disassembly/Assembly procedures
It is recommended dealing with Clean box, to keep maintaining the dustproof environment.
(Refer to "3.2. Clean Box" section of this service manual for details.)
IMPORTANT:
1. When servicing the surrounding part with red line (refer to Fig.D1), it must be performed inside of satisfied clean level.
(Satisfied clean level: Less than class 10,000 Federal Standard 209D).
As for procedure, refer to the "5 Maintenance" for details.
2. To minimize the possibilities/risk of getting the dust/dirt on the lens surface, keep covering the lens unit with Lens caps
(front & rear), other than necessary cases.
3. Do not touch the surface of the lens glasses with your fingers.
4. Blow off the dust on the surface of the lens with a blower brush.
5. Use lens cleaning KIT (BK)(VFK1900BK).
Proceed disassemble/ and assemble, by referring the following table and Fig.D1
NOTE:
1. When tightening the screw, use a Torque driver (RFKZ0456) by ordering the screwing order with specified torque
mentioned in each step.
2. The screw Ref.B206 is no need to remove for disassembly.
3. Use VFK1390 (small driver) when screwing/unscrewing the B206 and B210.
Fig. D1
8
Advertisement
Table of Contents
