Related Manuals for Homebase ANDORRA 2 SEATER SWING SET
Summary of Contents for Homebase ANDORRA 2 SEATER SWING SET
- Page 1 ANDORRA 2 SEATER SWING SET H159 x W117 x D156.5cm INSTRUCTION MANUAL IMPORTANT: Please read these instructions before using the product and retain for future use. HHGL Limited, MK9 1BA; HHGL (ROI) Limited, D02 X576...
- Page 2 Check you have all the components listed on page 3. Keep children and animals away from the work area; small parts could pose a choking hazard if swallowed. Do not stand or put weight on the component parts or the product, as this could cause damage. We do not recommend the use of power drills/drivers for inserting screws, as this could Domestic use only.
- Page 3 COMPONENTS Please check you have all components listed below. If you have any missing or damaged components, please contact your local store. Swing right arm Top cross beam Swing left arm Front upright support Arm connecting tube Rear upright support Seat assembly Lateral cross brace Canopy...
- Page 4 NOTE: When fastening with nuts and bolts, always use a washer (E) between the tube and the bolt or the tube and the nut. Step 1 Fasten the front and rear upright supports (2 and 3) at the top by using bolts (A), washers (E) and metal nuts (G).
- Page 5 Step 3 Insert the arm connecting tube (9) to the swing arm (7 and 8). Step 4 Fasten the arm connecting tube (9) to the seat assembly (10) by using bolts (C), washers (E) and metal nuts (G). Repeat the same procedure for both sides. Step 4 Fasten a swing arm tube (6) and a swing arm (7) to the seat back by using bolt (D), washers (E) and metal nuts (G).
- Page 6 Step 5 Hook the suspension springs (H) into the top of both swing arm tubes (6). Do the same procedure for both sides. Hang the opposite ends of the suspension springs (H) into the holes located on the angled braces of the top cross beam (1).
Need help?
Do you have a question about the ANDORRA 2 SEATER SWING SET and is the answer not in the manual?
Questions and answers