Loop Function In Auto Punch In/Out Mode - Fostex MR16 Owner's Manual

When the loop mode is active (while the auto punch in/out mode is inactive), the LOCATE
A and LOCATE B points are used as the loop start and end points. When the auto punch in/
out mode is active (while the loop mode is inactive), the LOCATE A and LOCATE B points
are used as the punch-in and punch-out points.
When both the auto punch in/out and loop modes are active, the LOCATE A and LOCATE
B points are used as the punch-in and punch-out points, while the loop function starts at
"the LOCATE A point minus the pre-roll time" and ends at "the LOCATE B point plus the
post-roll time", as shown below. The pre-roll time is initially set to four seconds, while the
post-roll time is set to one second.
<Note>: If you set the LOCATE A point to the beginning of a song (ABS ZERO) or set the
LOCATE B point to the recording end point (REC END) of a song, the pre-roll or post-roll
time is ignored.
Using the loop function in the auto punch in/out mode reduces the number of key presses,
allowing you to concentrate on playing.
You can change the pre-roll and post-roll time within the range between 0.1 and 10.0
seconds (in 0.1 second steps) in the menu mode (see page 142).
MR16
Owner's Manual (Advanced playback and locate functions)

Loop function in auto punch in/out mode

LOCATE A point
4 sec.
LOOP START point
LOCATE A point
(Punch in point)
LOOP START point
LOCATE B point
1 sec.
LOOP END point
LOCATE B point
(Punch out point)
LOOP END point
51