Advertisement
3. Connect the USB flash drive, as shown below:
4. Connect the network and power, as shown below.
You have two options for network and power connections:
PC
Power over
Ethernet (PoE)
PC
PC connection
(optional)
Note: The IP phone should be used with the original power
adaptor (5 V/1.2 A) only. The use of a different power adaptor
may cause the damage to the phone.
If inline power (PoE) is provided, you don't need to connect the
power adaptor. Make sure the network switch is PoE compliant.
a. Upper USB port
b. Lower USB port
PC
AC power option
Power adaptor
PC connection
(DC 5 V)
(optional)
PC
PC
PC
IEEE 802.3af-compliant
PoE hub/switch
Startup
After the IP phone is connected to a network and supplied
with power, it will automatically begin the initialization process.
The phone will go through a series of screens and update the
firmware on the device; the first-time setup process takes
about 15 minutes and should not be interrupted. You will know
the phone is ready to be used when the 911 address appears
in the screen of the device.
Basic call features
Placing a call
Using the handset:
1. Pick up the handset
2. Enter the number, and then press the Send soft key
Using the speakerphone:
1. With the handset on-hook, press
2. Enter the number, and then press the Send soft key
Using the headset:
1. With the headset connected, press
headset mode
2. Enter the number, and then press the Send soft key
Note: During a call, you can alternate between the headset,
hands-free speakerphone and handset modes by pressing the
Headset key, the Speakerphone key or by picking up the
handset. Headset mode requires a connected headset.
Answering a call
Using the handset:
Pick up the handset.
Using the speakerphone:
Press
.
Using the headset:
Press
.
Note: You can reject an incoming call by pressing the Reject
soft key.
User guide
to activate the
3
Advertisement
