Power Wheels P5064 Owner's Manual page 11

Wrench
/ " -16 Hex Nut
3
8
Rear Wheel Assembly
7
• Fit a / " -16 hex nut onto the end of the rear wheel assembly.
3
8
• Tighten the hex nuts on both sides of the rear wheel assembly
with the wrench.
Hint: An extra wrench has been provided to hold the hex nut
on one side of the rear axle while tightening the hex nut on
the other side.
Hubcap Cover
8
• Fit and snap a hubcap cover to each hubcap.
P5064pr-0922
ASSEMBLY
Hubcap Cover
9
• Turn the vehicle so that the front end is toward you.
• Fit the steering linkage assembly to the front end of the vehicle.
• Insert two #12 x 1 / " screws into the holes in the steering
1
4
linkage assembly. Tighten the screws.
• Pull the steering linkage to be sure it is secure. If it is not secure,
tighten the screws a few more turns.
/ " Washer
7
16
Front Axle
10
• Slide a / " washer onto a front axle.
7
16
• Slide a bushing, ring side first, onto a front axle.
Steering Linkage
Assembly
Ring Side
First
Bushing
(Ring Side First)
11