Table of Contents
Advertisement
components.
2. For reassembly after operation checks or replacement, reverse
the respective procedures. / Special reassembly procedures are
described only when required.
3. Select items from the following index when checks or
replacement are required.
4. Refer to the Parts No. on the page of "Parts Location and
Replacement Parts List" (Section 23), if necessary.
10.1. Disassembly flow chart
The following chart is the procedure for disassembling the casing and inside parts for internal
inspection when carrying out the servicing.
To assemble the unit, reverse the steps shown in the chart as below.
10.2. Gear for servicing (jig) Information
1. This unit has a gear which is used for checking items (Open/Close
of disc tray, up/down operation of traverse unit by manually) when
servicing.
2. For preparation of gear (for servicing), perform the procedures as
PDF created with pdfFactory Pro trial version
12
www.pdffactory.com
Advertisement
Table of Contents
