Table of Contents
Advertisement
disassemble the Infrared Remote Control Unit. However, the
battery cover is available separately as a replacement part.
4. Main Cam Push Nut (Ref. No. 414) is not reusable.
If removed, install a new one.
12.1.3. Electrical Replacement Notes
1. Unless otherwise specified;
All resistors are in
2. Abbreviation
RTL: Retention Time Limited
This indicates that the retention time is limited for this item. After
the discontinuation of this item in production, it will no longer be
available.
NR: Non Repairable Board Ass'y
MGF CHIP: Metal Glaze Film Chip
C CHIP: Ceramic Chip
COMPLX CMP: Complex Component
W FLMPRF: Wirewound Flameproof
C.B.A.: Circuit Board Assembly
P.C.B.: Printed Circuit Board
E.S.D.: Electrostatically Sensitive Devices
3. SERVICE OF CHIP PARTS
When servicing chip parts, please use a soldering iron of less than
30 W. Refer to
page.
4. When replacing 0
5. When installing the IC2501 (AN3846SC) or Capstan Stator C.B.A.,
be sure to apply Silicon Grease (VFK1301). Refer to "Capstan
Stator C.B.A." of MECHANISM SECTION in DISASSEMBLY/
ASSEMBLY PROCEDURES.
6. Since the UHF/VHF TUNER/TV DEMODULATOR UNIT (Ref. No.
743) has already been pre-adjusted at the factory, do not try to
adjust the UHF/VHF TUNER/TV DEMODULATOR UNIT. The UHF/
VHF TUNER/TV DEMODULATOR UNIT replacement part is
available as a complete assembly unit only.
, K = 1,000
"IC, TRANSISTOR AND CHIP PART
resistor, a wire can be substituted for it.
, M = 1,000 k
81
.
INFORMATION"
Advertisement
Table of Contents
