Table of Contents
Advertisement
Term and Acronym Definitions
TERM/ACRONYM
2 Groove
AC
Accumulation
ATO
Back pressure
BF
BHCS
BOM
Carton or Case
CB
CCW
CDAC 1.0
CDDC 1.0
Center Drive
CW
DC
Diffuse
Discharge
Divert
Double-dispense
Drive Card
Drive Pulley
Dutchman
End stop
Published November 2021
DEFINITION
Roller format which uses O-Rings to transfer rotational motion from one roller
to another in DC conveyor.
Alternating current
The collection or staging of multiple cartons, cases, or totes of product on
conveyor.
Assembled to Order; Orders consisting of standard products
Pressure against carton(s) in the direction of carton flow resulting from weight
of densely accumulated cartons.
Between frame; this refers to the distance between conveyor bed side frames.
Button head cap screw
Bill of Materials
Term for a conveyable item (cardboard box, tote, etc.)
Carriage bolt
Counter-clockwise
Conveyor Director Control Card 1.0 - Bastian Solutions' dual zone control card
designed for zero pressure control of low-voltage (24V nominal) DC solenoids
for belt-under roller conveyor.
Conveyor Director Control Card 1.0 - Bastian Solutions' dual zone control card
designed for zero pressure control of low-voltage (24V or 48V nominal) DC
powered MDRs.
Drive format of AC conveyor where the drive unit is mounted underneath the
conveyor.
Clockwise
Direct current
A photoeye format that houses both the emitter and receiver and senses an
object when the light beam is reflected back to the sensor. This type of
photoeye is a standalone unit and does not use reflectors.
The point where cartons, cases, or totes exit a conveyor or similar unit used in
a material handling system.
(noun) A conveyor unit used to change the direction of a carton, case, or tote
in a controlled manner. (verb) To change the direction of a carton, case, or
tote in a controlled manner.
Event in which two or more cartons are dispensed when a single carton, case,
or tote is requested. This is generally a result of two cartons, cases, or totes
being in full contact just prior to reaching the dispensing point.
A control card used to power and control the logic of one or more zones of
zero pressure conveyor.
A motor-driven pulley used to transmit rotational energy to linear motion in AC
belts.
A short, removable section of belt used to take up slack developed in AC belts
after they have stretched from long term use.
A plate mounted to the end of a conveyor with the intent of stopping and
holding a carton, case, or tote in position until removed by a user or diverted
by a conveyor unit.
Installation and Maintenance Manual: RZPAC
Rev. B
3
Advertisement
Table of Contents
