Makita DFT060T Instruction Manual page 10

Error code Tool performance
and status and function
symbol on
screen
- Alert for insufficient
fastening
Waiting function
between pre-set
fastening steps
- Low-battery alert
- Error alert for heat
detection of motor
Maintenance notice
Alert for storage
disabled
- Error alert for data
communication with
computer
- Status indicator for
data communication
with computer
Tool status
The tool raises an alert for
incomplete fastening under the
following operating conditions.
(1): The trigger switch is
released before the pre-set
fastening torque has been
achieved.
(2): The tool stops automati-
cally after classifying fastening
errors.
The tool is sitting idle, after one
of the pre-set fastening steps
has been completed, waiting to
follow the next pre-set fasten-
ing step.
* A status symbol ( ) flashes
in the display screen.
The battery is becoming low on
power, and the battery cartridge
needs to be recharged or
replaced with fully charged one.
The motor temperature cannot
be monitored properly for a
number of technical reasons
including line breaks.
Maintenance notice will be
posted for optimum operational
reliability when the accu-
mulated maintenance count
reaches the pre-set number.
* A status symbol ( )
appears in the display screen
when the accumulated mainte-
nance count reaches the pre-
set "Stop Count" number.
Up to 1,000 fastening result
data can be saved in the tool
memory. The number of unread
data in the memory reaches to
the maximum.
* A status symbol ( )
appears in the display screen
when the storage capacity
reaches the maximum.
The tool raises an alert for
communication error in the
wired environment.
The tool informs that data
communication has been
securely established in the
wired environment.
10 ENGLISH
LED indicators/beeper status
LED indicators Beeper
(1): The LED A long
indicator lights beep
up in red for
approximately two
seconds.
(2): The LED
indicator flashes
in yellow and red
alternately for
approximately two
seconds.
The LED indicator -
lights up in green.
The LED indicator A series of
slowly flashes long beeps
in red.
The LED indicator A series
briefly flashes of short
in red. beeps
The LED indicator -
flashes in yellow.
The LED indicator -
flashes in yellow.
The LED indicator -
flashes in yellow.
The LED indicator -
flashes in green.
Action to be taken
Retighten the screw.
-
Replace the battery
with fully charged
one.
Remove the battery
cartridge and cool
the tool down. If the
indicator remains lit,
ask your local Makita
Service Center for
repair.
Reset the mainte-
nance count in the
application software
designed for this
tool.
Load the fastening
result data saved
in the tool memory
using the application
software designed
for this tool.
Link the tool again
with the application
software designed
for the tool after
restarting the
application.
-