Table of Contents
Advertisement
FIESSLER
E L E K T R O N I K
Swivel mounting
The TLCT/ILCT can be mounted on the side or the rear with the help
of the accompanying swivel fixtures. A long and a short swivel fixture
are included.
The short swivel fixture is to be attached by means of the
accompanying plastic bolt.
The long swivel fixture is to be attached using the lock nuts of the
TLCT/ILCT light curtain's M12 connector.
Depending on the required type of mounting (lateral or rear), the
fixture must be installed as explained further below.
Lateral mounting
Fiessler Elektronik
Kastellstr. 9
D 73734 Esslingen
Assembly
2
Rear mounting
Important:
The light transmitter and receiver must be attached to stable, rigid,
plane-parallel structures.
Make sure that the profile is resistant to torsion, otherwise proper
optical adjustment will not be possible.
When mounting the transmitter and receiver, ensure that both
devices' connectors are located on the same side.
BA - TLCT / ICT_1129
BA - TLCT /
Phone: +49 / 711 / 91 96 97-0 Internet: http://www.fiessler.de
17
Fax:
+49 / 711 / 91 96 97-50 E-mail: info@fiessler.de
Table of Contents
Mounting and adjustment
2.4
Fixing screw
Short swivel fixture (with fixing screw)
attached via a plastic bolt
Long swivel fixture attached via an M12
connector
Adjustment:
Perform corrections to the
transmitter's and receiver's
mutual alignment until the
7-segment display and
adjustment-aid LED go off.
LEDs and displays are
described on
Page 6
Advertisement
Table of Contents
