How To Assign User Codes And Attributes - First Alert FA130CP User Manual

The following lists the various command strings for adding user codes and attributes.
Refer to the User Setup chart at the back of this manual for factory
assignments of user attributes and to keep a record of user programming.
Add User Code:
Delete User Code:
Authority Level:
Factory Assignments:
users 03-16 = 0
Access Group:
Factory Assignments: none
RF User Number:
Factory Assignments: none
Pager On/Off:
Factory Assignments:
users 01-16 = 1 (on)
System Master code + [8] + user no. + new user's code
User 01 = installer
User 02 = master
The Keypad beeps once to confirm that new user was added.
System Master code + [8] + [user no.] + [#] [0]
The user code and all attributes programmed for this user number,
including any associated RF keys, are erased from the system.
System Master code + [8] + [user no.] + [#] [1]+ auth. level
Authority Levels (see definitions on previous page):
0 = standard user
1 = arm only
System Master Code + [8] + [user no.] + [#] [2]+ group (1-8)
You can assign users to a group, then set an access schedule that
defines the times this group of users can operate the system. The
system ignores these users outside the scheduled times.
System Master Code + [8] + [user no.] + [#] [4]+ zone no.
Use this command to assign a wireless button device (keyfob) to this
user (keyfob must be enrolled in system first; see installer).
Zone number: enter the zone number assigned to a button on the
keyfob that will be used for arming/disarming by this user.
System Master Code + [8] + [user no.] + [#] [5] + 0 or 1
ou can program a user so that a message is sent to a pager
Y
whenever this code is used to arm or disarm the system.
Paging On/Off: 1 = allow paging; 0 = no paging for this user
User 03-16 = standard users
(factory set master code is 1234)
2 = guest
3 = duress
– 31 –