Advertisement
10. Place one side panel in position against a side
angle and down on top of the front panel. Start one
1/4" x 1" screw through the center hole in side
panel and side angle. Secure with hex nut and flat
washer. See figure 7. Make only finger tight at
this time.
11. Start one 1/4" x 1" screw through front hole on side
panel and side angle. Start another 1/4" x 1" screw
through top hole on side panel and front angle
assembly. Next, place a support strap over these
two screws and secure it with flat washers and hex
nuts, making only finger tight at this time. See
figure 7.
12. Repeat steps 10 and 11 for the other side panel.
FIGURE 7
13. Assemble one 1/4" x 1" screw through bottom hole
in side panel and front angle assembly. Secure
with a flat washer and hex nut, making only
finger tight at this time. Repeat for the other side
panel. See figure 8.
14. Tighten all loose nuts and screws securely at
this time.
FIGURE 8
4
Advertisement
