Rottner PS310/E01 Instructions

ELECTRONIC LOCK
PS310/E01, PS310/ES01, PS310/E02
INSTRUCTIONS
1
OPERATING UNIT
Fig. 1.1
1 - keyboard *, 2 - folding handle, 3 - green LED [G],
4 - red LED [R], 5 - contacts for emergency power supply
2
GENERAL INFORMATION
2.1 Master code [PIN1]
Number combination (6 to 8 digits) to open the
electronic lock and the authorized code for making the
settings.
Electronic lock
PS310/E01, PS310/ES01, PS310/E02
When you put your safe into operation, change the
factory master code (see section 4.1) to a personal
master code. Test the master code you have stored
several times before storing valuables in your safe.
Factory-master code:
1–2–3–4–5–6
2.2 User code [PIN2]
Number combination (6 to 8 digits) to open the
electronic lock and to make limited settings.
The electronic lock has no user code active from the
factory. To activate a user code, follow the procedure
described in section 4.2.
2.3 Signals
 1
[ G] Short acoustic signal and green LED light
up once (3) - confirmation when pressing a key on the
keyboard (1).
 2
[ G] Short double-beep and two green LED
light up (3) - confirmation of a correct entry(eg: code).

[ R]-- Long acoustic signal and red LED (4)
flashes once - error message (eg: wrong code).
 5
[
R] Short simple acoustic signal and five red
LED light up (4) – Warning: Battery Low. See point
5..1 Battery change.
* For variants of the keyboard, use the «#» key instead
of the «Enter» key to confirm the entry.
www.rottner-tresor.at
3 Open / Close
3.1 Opening the electronic lock
3.1.1 Opening with the factory master code
[ON][1][2][3][4][5][6][Enter*]
3.1.2 Opening with a personal master code
[ON][PIN1][Enter*]
3.1.3 Opening with user code
[ON][PIN2][Enter*]
3.1.4 Opening with a dual-function code
[ON][1-9 (User)][Enter*]
[PIN2][Enter*]
[1-9 (User)][Enter*]
[PIN3][Enter*] – within 1 Minute
After correctly entering the first code [PIN2] [Enter],
the second code [PIN3] [Enter] must be entered
within 1 minute, while the green LED [
2.3) lights up every 5 seconds.
3.1.5 Opening with the time delay
[ON][PIN1 oder PIN2][Enter*]
[Wait for the programmed time delay]
[PIN1 oder PIN2][Enter*]
[PIN1 or PIN2] must be entered again while the
programmed opening window is active.
After the time delay expires an alarm sounds.
If the [Enter] key is pressed during the opening delay,
the opening delay is canceled and the opening must be
restarted.
After entering a correct code, the green LED (3)
lights up briefly and you can open the electronic lock
by turning the hinged handle (2) clockwise to the right
within 5 seconds.
Ver. 1/2 01-2019
Instructions
1

G] (see point